Adhesive products

It is important! The specification is a general specification.
It is necessary to consult with the Technical Department of BI. J. Technologies, before performing the work.
Be sure to follow the relevant standards.

Specification for bonding ceramic or marble tiles on a concrete foundation

This specification is intended for gluing ceramic tiles, marble, granite and the like on a concrete foundation.
For application with acrylic glue. 17 and glued to BG tiles. 40
The method of adhesion is by means of a sphechtel method or a thick method.

Adhesive layer thickness:
3-5 mm and will be performed with a jagged fork when the size of the teeth is suitable for 9 thickness for tiles up to 10 thickness). X9 applied adhesive layer. (Memorization)

The tiles must be completely dry and free of dust, scraps, and the like.

The area to be glued shall be smooth, aligned and spaced, with the maximum permissible deviation not exceeding 0.1%
Per mA in each direction (1 mm per 1 meter and not more than 2-3 mm in any case).

Stitch Marking:
The surfaces will have stitches of at least 4X4 m horizontal and vertical. These stitches will be cleaned from clay residues to the appropriate depth. These relaxation stitches will be filled
The PU-40 must be filled by force or rifle according to the width of the seam.

Instructions for use and implementation:
1. The material will be mixed in a container with an 400 rpm electric mixer and a suitable mixing rod.

2. Prepare a paste mixture:
By adding BJ. 40 The tank contains a percentage of 15 BJ. Bond 17 And 15 percent water. Mix with an electric mixer (at a speed of 400 rpm and with a suitable mixing rod) until the mixture is homogeneous and without lumps.
If the mixture is too thick, you can add water until you get the desired work.

3. Infection:
Apply a thin layer of adhesive on the bottom of the tile or stone with a serrated mortar. Also apply a layer of adhesive on the designated section
Paste, place the tile in place, and press until it is tightened with the appropriate tools. Make sure the adhesive layer is behind the tile
Will be full to the entire tile area. To create intervals, use a spacer adapter.

4. cleaning:
Immediately wipe with a damp sponge and excess glue on the tile, while the glue is still fresh. Places
For the relaxation saps, pass and clear the interval to the appropriate depth (in order to avoid need

5. Planning quantities and times:
The amount of material designed for adhesion shall not exceed the amount sufficient for application within 10-15 (according to temperature).
Do not apply glue to large areas, but to each tile separately, before applying it. Do not add water to the mixture that has begun to crystallize or harden.

6. Relaxation joints:
Will be fulfilled In PU-40 After a week, the infection is finished (and not before).

All of the above is only a recommendation, given according to the best knowledge we possess and our extensive experience.
However, because the work is not under our control, the factory's warranty is limited to the quality and quality of the product only.
The operation must check compliance with its needs and proper performance of the work.

Contact Us

logo bg bond
BJ (Israel) Technologies Ltd., Kibbutz Beit Guvrin, moving post to Lachish South, 79370 //
Phone: 08-6874236 Email: info@b-gtech.com

Copyright © BG Bond. All rights reserved
logo ashtrum2